Comdial 8024S Specifications download pdf (Page 348)

Automatic Station Relocation

With this feature, the system will automatically recognize a particular station should that

station be relocated to a new station port. When someone places a telephone at a new port

location, it will continue to provide the same class of service parameters and respond to

the same extension numbers as it did at the original station port. A programmer must

enable this system feature using system class of service programming. As an added

feature when someone plugs an LCD speakerphone in a new station port, the system will

prompt the user on the display to verify the relocation of features.

Auxiliary Equipment Interface

An installer can use the auxiliary equipment interface to connect a telephone device or a

data device to an outside line ahead of the common equipment. The system can detect an

off-hook condition in a device that an installer has connected to the auxiliary equipment

interface, and turn on the status light for that line at telephones that have that line

appearance. It does this to indicate that the line is busy and not available for station use.

Auxiliary equipment interface connections provide connections to lines 2 and 4. A user

cannot interrupt an external device by pressing the line button unless the line has been

programmed to be non-private.

Auxiliary Ringer Interface

The auxiliary ringer interface provides “dry-contact” relay closures which track the

ringing pattern whenever the system sends ringing to a programmable destination.

Programmers can program relay control to be activated when the system sends ringing to

station port 17 or to the paging port.

When programmed for station port 17 ringing, an installer often uses an external device

to provide loud ringing. When programmed for paging port ringing, an installer often

installs an external paging amplifier to sound the rings. The system supplies ringing tones

to the paging port along with the relay closures. It can send the ringing tones to the input

of an external paging amplifier and the installer can arrange the wiring so that the relay

closures energize the paging amplifier while it is receiving the ringing tone. Use system

class of service programming to choose either the paging port or station port 17 for the

ringing port relay control. Also use system class of service to determine the type of

ringing sent to the paging port. Use station class of service programming to determine the

type of ringing that the system sends to station port 17.

Programmers can arrange for the system to send ringing tones for particular lines

through the PA port. They can choose between intercom tone and DTMF signaling tone

for the PA port ringing. They should choose the intercom tone if they desire a soft tone

and the DTMF tone if they desire a loud tone.

No comments

Comdial 8024S Specifications Page 348